Description
 |
| • NABAKEM Resin Stripper SS#1 is a resin stripper containing strong exfoliation solvent penetrating into the resins fixated on metal mold and softening them. • It is manufactured for GRP industry. Also, the product can remove zinc stearate and vinyl resin fixed on mold surface and strips plastic dye spot. • No influence to metal surface. No residues. • Using the solvents lie aceton and MC have created many side effects. • NABAKEM Resin Stripper SS#1 has same dissolubility and cleanability without these side effects. • As pretreatment in heating process requred by other resin strippers containing water is not necessary, using finished product creates better effects. • Unlike existing solvents including aceton and MC, its vaporization speed is much slower. • It does not do any harm to human body even when inhaled. • Much lower amount is required for the same effects as existing solvents. • Therefore it is more cost-effective. With high igneous point and lower danger of fire, it reduces the costs for facilities preventing harmful materials. (Onsite test showed that one drum of Resin Stripper SS#1 substituted from 17 drums of aceton and MC.) |
 |
| • Following resins fixed on metal mold surface polyacetal resins(Delrin) polyamides (Nylon-Zytel) polyvinylchloride resins other resinous materials polyvinyl formal resins polyester (Mylar) certain elastomers urethanes • Manual tools • Injection system • Mixing tank • Feeder lines • Compressor • Injection mold • Automated production system |
 |
| • Apply it sufficiently to make it penetrate into whole fixated contaminants, and leave it for about five minutes. • When it fully penetrates into contaminants , rub with cloth or tool to remove. • In case of mold for injection molding, apply with mold mounted on injection molder and tap applied surface lightly 30 minutes later. • Repetition over two or three times can remove contaminants 1. SPRAY method : Short-time spray during machinery operation removes polyacetal residues in mold, enabling you to proceed with the next work. Recommended mold temperature is 82℃∼93℃. As residues melt away down through eject part, apply the product three or four times for finish even after residues are removed. 2. Dipping method 3. BRUSHING method |
